Dd wrt v24 sp2 outdoor band full#
Dd wrt v24 sp2 outdoor band pro#
Dd wrt v24 sp2 outdoor band Pc#

Same problem here for iPad, iPhone and two MacBook Pro using a wrt-350n running build 14929.

However, on any other device (computer, Blackberry) I have no issues at all. I've disabled all security and it messes up.Īlso, I can sometimes get wifi working all night long and then other days it'll last 1 minute and I'll have to reconnect wifi. I've done everything I can think of in terms of getting it to work. I wish I could come up with some more useful suggestions but I am at a loss to explain what could be causing the sort of behavior you describe. You might want to try a few fundamental changes, like temporarily turning off encryption t a static IP on the devices rather than using DHCP.etc, and see if anything changes at all. No problems here using an iPad and iPhone 3GS with latest K26 build (14929 ) on a WRT610N v1. Otherwise I'll have to go back to my previous router. Then my previous SSH connection will work again, won't have to re-login. If I leave the terminal with the SSH connection unused for 1 or 2 minutes, I have to go to the iPhone, disable WiFi and reenable it again. I have to write a sort of terminal screen saver in shell to keep the connection alive, like this: 'while true do echo 1 sleep 1 done' When I log in into my jailbroken iPhone with SSH, I am able to keep the connection up only if something is constantly being transmited. I believe this problem lives in a more electrical or radio frequency layer. I'm not using WPA2, just plain WEP so I guess this is unrelated to security model.

Dd wrt v24 sp2 outdoor band full#

It shows full signal strength but won't connect to anything. Same here iphone just says no hope some clever cloggs knows the issue This is happening on 2.4ghz and 5ghz so I can't imagine it is the wireless anymore. When it goes bad the interface either reports a 169 ip or empty. Literally have to toggle wifi on and off every 5 minutes to get a new connection/new ip.

Dd wrt v24 sp2 outdoor band Pc#

Multiple macbooks, iPad, iPhones and another PC just will not keep the wireless IP assigned via dhcp. I restored the factory Netgear firmware for my WNDR3700 and it got worse. I have to turn wifi off and on again for it to work again. It will still show the wifi connection at full strength, and in the connection settings it will show blank. Usually it will work for about a minute though. I can connect for sometimes just 10 seconds before it stops working. I switched both radios to use WPA2 Personal with AES only and the 2.4 to channel 6. Looking for bricks and spare routers to expand my collection. (Don't PM about complicated setups otherwise) Read the forum announcements thoroughly! Be cautious if you're inexperienced.Īvailable for paid consulting.

You need WPA2 AES only for N spec and you're using a bad channel on the 2.4GHz band that overlaps the entire spectrum. Using WPA2 Personal Mixed with TKIP+AES as well. Most are defaults from the fresh firmware install.